QUALITY

Interlinking between Articles
Visual Navigation

Quality, x, is the mass fraction of vapor in a liquid/vapor mixture. In thermal equilibrium, the quality of a two-phase mixture is directly related to heat input and is sometimes called the thermodynamic quality. For example, if an amount Q of heat is applied to a mass of liquid M at saturation temperature, then the mass of vapor generated is MG = Q/ΔhLG where ΔhLG is the latent heat of vaporization. Hence the quality of the two-phase mixture created is given by

If a liquid is flowing in a pipe of diameter D with mass velocity m as shown in Figure 1 and a uniform heat flux q is applied to the walls, then measuring distance L from the point A, where the liquid reaches saturation temperature Tsat,

or

However, in most practical situations thermal equilibrium does not apply and the true quality is often different from the equilibrium quality calculated from a simple heat balance of the type described above. For example, at the lower quality end of the boiling process (A) part of the heat input may be used in superheating the liquid and the amount of vapor generated correspondingly reduced. Similarly at the higher quality end (B) the vapor may be superheated while droplets of liquid remain in suspension so that the true quality is less than that calculated on the basis of thermal equilibrium (see Boiling). Equilibrium quality is sometimes denoted by xe and actual quality by xa.

Quality, x, in thermal equilibrium.

Figure 1. Quality, x, in thermal equilibrium.

This article belongs to the following areas:

Q in A-Z Index
Number of views: 5519 Article added: 2 February 2011 Article last modified: 7 February 2011 © Copyright 2010-2014 Back to top